SC-310 Metal Pre-Clean

SPECIFICATIONS
Physical Appearance......................................... Clear, colorless liquidOdor................................................................... Mild ether odor
Specific Gravity.................................................. 1.060
pH...................................................................... 13.0 (conc.) 11.4 (use dilution)
Viscosity............................................................. 1 centistoke
Biodegradable.................................................... yes
Freeze Point....................................................... -6 C.
Phosphorous as % P.......................................... None
Flash point.......................................................... None
DIRECTIONS
Apply METAL PRECLEAN with a pump up sprayer or a pressurized pot sprayer. Spray directly to metal surface, working from bottom to top of surface. Let METAL PRECLEAN soak for approximately 3 - 5 minutes. Rinse with a hot high pressure sprayer. Do not allow chemical solutions to dry on surfaces being cleaned. METAL PRECLEAN may be used through hot pressure washing equipment if water hardness is below 50 ppm. If hardness is above this level, a water softener may be needed.
WARNING: May cause eye and skin irritation in concentrated form. Harmful if swallowed. Contains alkaline builders, 2-butoxyethanol and biodegradable surfactants.
FIRST AID
If eye contact occurs, flush for several minutes under running tap water, then seek medical attention. For respiratory system and ingestion, seek medical help.