Chemical 1: 2-Step Truck Wash System
CHEMICAL-1 is the first step of a two step cleaning system designed to be used with a two step cold water high pressure washer. This system was designed to clean over-the-road trucking equipment such as trailers and tractors. This two step system, when used as directed, is the most efficient cleaning system available today.
This system will remove heavy soils including carbon stack stain from diesel exhaust and the hard to remove magnetic road film on painted surfaces. A powerful combination of fast acting acids and biodegradable detergents. CHEMICAL-1 dissolves corrosion, emulsifies oil, disperses dirt and gives aluminum a dazzling satin finish.
SPECIFICATIONS
Physical Appearance............................................ Clear, colorless liquid
Odor................................................................. Pungent acid odor
Specific Gravity................................................... 1.015
pH.................................................................... Below 2.0 (concentrate)
Viscosity............................................................ 1 centistoke
Freeze Point....................................................... -8C
Phosphorous as %P............................................. None
Biodegradable..................................................... Yes
DIRECTIONS:
Mix CHEMICAL-1 (RTU) to 30 parts water and apply to the dry vehicle surface from the bottom up. Using the machines electronic switching mechanism, switch to the CHEMICAL-2 step and apply from the bottom up. Switch to the rinse cycle of the pressure washer and detail clean from the top down. Always keep the pressure nozzle no more than 6 inches from the surface while detail cleaning. Never clean an area larger than you can reach while standing in one position. Do not allow any of these solutions to dry on surfaces. Do not use on glass, polished or anodized aluminum.
DANGER: CAUSES BURNS. MAY BE ABSORBED THROUGH SKIN AND CAUSE DAMAGE TO BONE.
Contains hydrofluoric and biodegradable detergents. Avoid contact of undiluted products with skin or eyes. Avoid continued inhalation of mists in spraying or other applications. Wear goggles, neoprene aprons and gloves when handling product.
FIRST AID: If eye or skin contact occurs, flush thoroughly with water for 15 minutes. See the SDS for additional information. This product is dangerous if improperly used. If ingested, give water or milk. Do not induce vomiting. Get medical attention immediately.